Rough Country 907S - Manual (Page 5)

25. Longer brake lines are not required in the front
or rear with this kit unless the sway bar is dis-
connected or this lift is combined with another
lift. If disconnects are used, longer brake lines
are required and available from Rough Country.
26. Tighten the lower suspension arms to frame
bracket. Tighten to 130 ft. lbs. (both sides).
27. Align the reference marks on the adjustment cams
and lower arm axle brackets and tighten to 130 ft.
lbs.
28. Check to be sure the body is centered over the
axle. Unlocking the steering wheel and turning the
wheel to move the body, do this until the newly
drilled track rod extension hole line up. Install the
track rod with the stock bolt/flag nut and using a
15mm wrench. See Photo 11. Torque to factory
specs.
PHOTO 11
Reuse Factory
Hardware
INSTALL TRACK ROD ON AXLE