Rough Country 257.20 - Manual (Page 16)

1. Unplug the license plate light connector and if equipped the trailer wiring connector. See Photo 1 & 2.
2. Remove the 3 bolts from the driver and passenger side frame as shown in Photo 3 (Driver Side Shown) that mount
the bumper to frame. These six bolts ( three per side) are removed using a 18mm and 15mm socket / wrench. Re-
tain the stock hardware.
3. Using a 21mm socket remove the 4 bolts located in the receiver hitch. See Photo 4 & 5.
4. Remove bumper and set aside.
BED INSTALLATION INSTRUCTIONS
PHOTO 1 PHOTO 2
PHOTO 3 PHOTO 4
PHOTO 5
UMPLUG HARNESS UNPLUG HARNESS
REMOVE BUMPER BOLTS REMOVE HITCH BOLTS
REMOVE HITCH BOLTS