Rough Country RC611 - Manual (Page 6)

29. Reinstall hose on the brake booster. See Photo 19.
30. Install the .25” self tapping bolt into supplied radiator drop brackets using a deep well 7mm socket and hammer, by
striking the bracket and pushing it on the stud. See Photo 20. Make sure stud is secured into bracket.
31. Using a 7/16 socket remove the six bolts that hold radiator on. See Photo 21. Note: Use caution when removing
the radiator mounting bolts to not allow the radiator to fall and possibly damage the radiator or surrounding
components.
32. Remove all 6 body clip from core support and install one on each of the radiator drop brackets. The clips will install
in the end hole on the radiator brackets. See Photo 22 & 23.
33. Install radiator support drop brackets onto core support using the supplied washer 1/4” washers and 1/4” nuts.
Tighten bolts using 7/16” socket and make sure brackets are hanging straight down. See Photo 24.
Photo 19
Install the coupler on new hose and stock hose
Photo 20
Install 1/2” studs
Photo 21
Remove the radiator bolts
Photo 22
Photo 23
Remove the stock clips
Install the clips on the supplied brackets
Photo 24
Make sure all brackets are straight