Rough Country 591.20 - Manual (Page 3)

14. Insert the adjustable end of the lower radius arm into the radius arm drop bracket as shown in Photo 7. Bolt into
place using a 3/4” x4.75” bolt, nut and washer provided in the kit bag. Using a 1 7/8” wrench tighten the jam nut.
Center of end to center hole of opposite end should be 36 1/8”. Reattach the ABS wire to the upper radius arm. See
Photo 8.
15. Repeat step 12-15 on the opposite side.
16. Using a 21mm wrench and 19mm wrench socket remove the factory track bar bracket from the frame. Retain stock
hardware for re-use
17. Position the Rough Country track bar bracket on the frame in the same position as the original and secure using the
factory hardware. See Photo 9. The track rod will be installed later.
11. Insert the radius arm drop bracket into the stock location. Bolt into place using a 3/4” x4.75” bolt, crush sleeve, nut
and washer provided in the kit bag. Do not tighten at this time. See Photo 5.
12. Attach the upper control arm to the radius arm drop bracket in the top hole. Bolt into place using a 3/4” x4.75” bolt,
nut and washer provided in the kit bag. Do not tighten at this time.
13. Attach the control arms to the axle using the stock hardware. See Photo 6. It may be necessary to use the rear
nut from the frame mount due to some models having the radius arm nut welded to the radius arm.
Photo 8
Photo 6 Photo 5
Photo 7
Crush sleeve installs in bracket here
Photo 9