Rough Country 202S - Manual (Page 5)

15. Reinstall the sway bar on the lower control arm using a15mm
wrench
.
16. Install the upper control arm / ball joint assembly onto the
knuckle with the supplied and castle nuts/cotter pins. Tighten
using 3/4
” wrench to 50 ft/lbs. DO NOT OVER-TORQUE
THE CASTLE NUT.
17. Reinstall the tie rod end into the knuckle with factory hard-
ware and using a 21mm wench.
18. Reinstall the driveshaft with the factory hardware using a
11mm wrench.
19. Install the brake line bracket on the new control arm with the
supplied 1/4 ” lock nut / washer and using a 7/16” wrench. See
Photo 13.
20. Reinstall the wheels/tires.
21. Jack up the vehicle and remove the jack stands.
22. Lower the vehicle to the ground.
Photo 13