Rough Country 51124-15 - Manual (Page 5)

51124 pg 5
Rev. B 0204
Step Four
Raise the header and bow assembly toward
the windshield and into position.
Inside the top, snap the fabric to the Rear
Bow (six snaps).
Snap fabric to
Rear Bow
Step Five
Close the header latches to secure the front of
the top to the windshield. Catch the hook in the
slot in the windshield frame and then close the
lever over it so that it lays flat against the wind-
shield frame.
Windshield
Frame
Windshield
Header Latch
Catch hook
in slot
Close lever over top of
hook to lay flush with
windshield frame
Step Six
Make sure that the Center Bow is centered in
the hook and loop flap inside the top. Do not
fasten the flap at this time.
Pull down gently on the Rear Bow and work the
plastic sewn to the rear corners of the top into
the retainer on the vehicle.
Pull down gently on
the Rear Bow and slip
plastic into retainer