Rough Country 75105-15 - Manual (Page 4)

PowerBoard ® – Installation Instructions
Rev. R 0713 75105 pg. 4
Remove the fuse from the
Wiring Harness.
The Motor Linkage mounts to the rear of the vehicle,
except for the passenger side of Super Cabs. If you
have a Super Cab, mount the Motor Linkage to the
front on the passenger side only. Slip the notches
in the Arms under the bolts and washers installed in
Step One. Tighten these bolts to 16 ft./lbs (22Nm).
Secure the bottom of the Arms with two Small Hex
Bolts and Small Washers.
Do not tighten the bolts at this time.
Rear Arm
Driver’s Side Rear Arm
Small Hex
Bolts
Small
Washers
If the sheet metal holes are misaligned,
you may need to fi le off the edge of the
sheet metal.
Rear
Front
Install Linkage and Trim
Clip - Driver’s Side
Remove the fuse from the Wiring Harness.
Failure to do so could result in severe
electrical shock which could harm the
installer and/or damage the vehicle.
Ground
Remove Fuse from
Wiring Harness
Remove the fan shroud. Set it aside to be rein-
stalled later.
Remove Fan Shroud
Use the 11" Cable Ties to mount the Controller to the
factory conduit. Route the Wire Harness under the
core support and down to the Controller. Connect the
harness to the Controller. Make sure the Connector
locking tabs are fully engaged.
Install Controller
11" Cable
Ties
Controller
Wire
Harness