Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Tuner- Six-Gun Diesel Tuner '06 -07 (PDA) Compatible with Optional PowerPDA & Speed-Loader User Manual
Page 8
8
96505 v.6.0
3.
Locate the two black wire harness
locking connectors between the
brake fluid reservoir and the air
conditioning compressor. Lift the gray
connector locks and disconnect the
38-pin connector pair and the 24-pin
connector pair. See Figure 3.
Note: Remove the wire harness
retainer to facilitate in connecting the
38 and 24-pin connectors.
4.
Insert the male 38-pin connector on
the Six-Gun harness into the female
38-pin connector on the factory
harness. Insert the female 38-pin
connector on the Six-Gun harness
onto the male 38-pin connector of the
factory harness. Repeat this process
with the 24-pin connectors. See
Figure 3.
5.
Go to the air box and remove the
stock Mass Air Flow (MAF) connector
located on the elbow of the air box
cover and set aside. Loosen both hose
clamps on the air intake tube and
remove the air intake tube and set
aside.
6.
Locate the MAF connector from
the Six-Gun Tuner harness and route
as shown in Figure 4. Follow the
factory harness located on top of the
engine that runs in front of the intake
manifold and behind the alternator.
Feed the connector under the
compressor outlet and under where
the air intake hose normally rest. See
Figure 5.
7.
Connect the Six-Gun tuner’s
(female) MAF connector to the factory
(male) MAF sensor and connect the
factory (female) MAF connector to the
Six-Gun’s (male) MAF connector.
8.
Reinstall the previously removed
air intake hose and tighten the hose
clamps.
Figure 2