Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Exhaust- Monster Exhaust, Single Passenger side exit '08-10 F-250_ F-350 - Manual (Page 4)

4
96534 v.4.0
Dear Customer,
If you have any questions
concerning the installation of
your Banks Power System,
please call our Technical Service
Hotline at (888) 839-2700
between 7:00 am and 5:00 pm
(PT). If you have any questions
relating to shipping or billing,
please contact our Customer
Service Department at (888)
839-5600.
Thank you.
1.
Before starting work, familiarize
yourself with the installation procedure
by reading all of the instructions.
2.
The exploded view (Figure 1, pages
4-5) provides only general guidance.
Refer to each step and section diagram
in this manual for proper instruction.
3.
Throughout this manual, the
left side of the vehicle refers to the
driver’s side, and the right side to
the passenger’s side.
4.
Disconnect the negative (ground)
cable from the battery (or batteries, if
there are two) before beginning work.
5.
Route and tie wires and hoses a
minimum of 6” away from exhaust
heat, moving parts, and sharp edges.
clearance of 8” or more is recommended
where possible.
6.
When raising the vehicle, support
it on properly weight-rated safety
stands, ramps or a commercial hoist.
Follow the manufacturer’s safety
precautions. Take care to balance the
vehicle to prevent it from slipping or
falling. When using ramps, be sure the
front wheels are centered squarely on
the topsides. When raising the front
of the vehicle, put the transmission in
park (automatic) or reverse (manual),
set the parking brake, and block the
rear wheels. When raising the back
of the vehicle, be sure the vehicle is
on level ground and the front wheels
are blocked securely. Caution! Do
not use floor jacks to support the
vehicle while working under it. Do
not raise the vehicle onto concrete
blocks, masonry or any other item
not intended specifically for this
use.
7.
During installation, keep the work
area clean. Do not allow anything to
be dropped into intake, exhaust, or
lubrication system components while
performing the installation, as foreign
objects will cause immediate engine
damage upon start-up.
General Installation Practices