Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Intake- Ram-Air Intake System '08-10 F-250_ F-350_ F-450 User Manual
Page 11
96496 v.6.0
11
rubber isolators in the support bracket.
Make sure to push the Filter Housing
all the way down into the rubber
isolators.
15.
Install the Banks Intake Tube into
the air cleaner bellows as shown in
Figure 10.
16.
Twist the Banks Intake Tube 180º
as shown in Figures 11, 12. Make
sure the bellows fully seat against
the stop on the Banks Intake Tube.
The Intake Tube tabs should line up
with the Filter Housing. Be careful
not to damage the MAF sensor while
twisting.
17.
Insert the warm air intake tube
into the Banks Ram-Air Housing cover.
Install the Housing cover onto the
Filter Housing.
18.
Install the supplied Phillips Truss
Head Screws into the cover. The
longer Screws go on the engine side
(Figure 13). Tighten the Screws with a
#3 Phillips screwdriver.
Note: Take care not to over tighten the
Screws and damage the Housing.
19.
Re-install the restriction gauge
and re-attach it’s connector.
20.
Re-attach the MAF connector to
the MAF sensor. Slide it’s connector
lock into the locked position.
21.
Tighten the air filter bellows’ hose
clamp to 44 lb-in (5 Nm).
22.
You have successfully completed
the installation of the Banks Ram-Air
Intake system. See Figure 14. Make
sure to go over all hose clamps for
tightness and connectors for a secure
fit.
-END, SECTION 2-
Figure 10