Banks Power Jeep Trucks: (Gas ’07 - 11 3.8L) Programmer- AutoMind, Quick Reference Guide - Manual (Page 3)

96809 v.3.0
3
96809 v.3.0
3
CaLiBratinG your vEhiCLE
1.
Locate the OBD II connection port in your
vehicle. The OBD II connection port is located
under the dash panel and can be located on
either side of the steering wheel. connect
your Banks AutoMind Programmer to the
vehicle OBD II connection port.
2.
Scroll up or down to Highlight ‘TuNE
VEHIcLE’. Press ‘OK’ to begin the calibration
process.
3.
Select ‘QuIcK TuNE’ to calibrate your
vehicle. Press ‘OK’ to continue.
4.
Select desired calibration to install and
press ‘OK’ to continue.
5.
Follow the on screen instructions and turn
the ignition key ‘ON/OFF’ when prompted by
the programmer, but do not start the engine.
6.
Select ‘YES’ to install the calibration or ‘NO’
to return to the ‘TuNE VEHIcLE’ menu, then
press ok.
7.
Follow the on screen instructions and
turn the ignition key ‘ON’ when prompted
by the programmer, but do not start the
engine. Follow on screen prompts and turn
ignition switch off and remove key when the
calibration process is complete.
8.
The calibration process is now complete.
unplug the AutoMind programmer and drive
your vehicle.
rEturn to StoCk
To return the Vehicle to stock calibration at
any time, follow steps 1-8 and select the stock
calibration when prompted to select a desired
calibration.
autoMind keypad
CaLiBratinG your vEhiCLE
1.
Locate the OBD II connection port in your
vehicle. The OBD II connection port is located
under the dash panel and can be located on
either side of the steering wheel. connect
your Banks AutoMind Programmer to the
vehicle OBD II connection port.
2.
Scroll up or down to Highlight ‘TuNE
VEHIcLE’. Press ‘OK’ to begin the calibration
process.
3.
Select ‘QuIcK TuNE’ to calibrate your
vehicle. Press ‘OK’ to continue.
4.
Select desired calibration to install and
press ‘OK’ to continue.
5.
Follow the on screen instructions and turn
the ignition key ‘ON/OFF’ when prompted by
the programmer, but do not start the engine.
6.
Select ‘YES’ to install the calibration or ‘NO’
to return to the ‘TuNE VEHIcLE’ menu, then
press ok.
7.
Follow the on screen instructions and
turn the ignition key ‘ON’ when prompted
by the programmer, but do not start the
engine. Follow on screen prompts and turn
ignition switch off and remove key when the
calibration process is complete.
8.
The calibration process is now complete.
unplug the AutoMind programmer and drive
your vehicle.
rEturn to StoCk
To return the Vehicle to stock calibration at
any time, follow steps 1-8 and select the stock
calibration when prompted to select a desired
calibration.
autoMind keypad