Banks Power Ford Trucks: (Diesel ’94 - 97 7.3L Power Stroke) Power Systems- PowerPack, Stinger-Plus & Stinger '94-98 4" Exhaust - Manual (Page 14)

33.
tighten the lower clamp on each
of the intake manifold hoses. attach
the tabs on the twinram and the
compressor outlet elbow with a 5 ⁄ 16
x 1-inch bolt with two washers and
a nylock nut. leave this bolt loose
enough for adjustment. Check all
bolts, hoses and wires around the
intercooler outlet tube for clearance.
Make any adjustments necessary,
then tighten all clamps and the
5 ⁄ 16 -inch nut and bolt.
34.
mark the plastic grille support
as shown in Figure 14 for cutting.
use a hacksaw to cut out the areas
indicated for intercooler clearance.
hold the grille support up to the front
of the vehicle and check that the
outside corners of the intercooler
Figure 13
14
96493 v.4.0