Banks Power Ford Motorhomes: (Gas ’93 - 98 7.5L Class-A) PowerPack System (Class-A, Ford chassis, non-cat) For Use w_ 460 EFI Engine - Manual (Page 13)

96444 v.3.0
13
the tailpipe as shown in Figure 11. The
heat shield should be installed in the same
fashion as mentioned in the preceding
steps. Tip may be slid in or out on the
tailpipe to match the body width. If the
tailpipe must be shortened to position the
tip near the coach body, cut the tailpipe to
place it 1 to 2 inches within the outside end
of the tailpipe tip. This will minimize any
heat discoloration of the chrome plating on
the tailpipe tip. The chrome tip is provided
with a single 3 1 ⁄
2
” U-clamp for mounting.
FIGURE 12