Banks Power Toyota Trucks: (Gas ’00 - 06 3.4, 4.0 & 4.7L Tundra) Exhaust- Monster Exhaust, Single Passenger side exit '00-06 3.4L, 4.0L & 4.7L - Manual (Page 4)

4
97059 v.4.0
1.
Disconnect the negative (ground)
cable from the battery (if there is more
than one battery, disconnect both
negative cables). Secure the cable so it
cannot accidentally come in contact
with the post.
2.
Raise the vehicle and support it
securely with properly weight-rated
safety stands, ramps or a commercial
hoist. Take care to balance the vehicle
to prevent it from slipping or falling.
When using ramps, be sure the wheels
are centered squarely on the topsides.
Place the transmission in park
(automatic), set the parking brake and
securely block the wheels that are on
the ground. CAUTION: DO NOT WORK
UNDER ANY VEHICLE SUPPORTED
ONLY BY A JACK. SEVERE INJURY
MAY RESULT.
3.
From under the vehicle remove the
factory exhaust starting at the front of
the muffler. Remove the tailpipe and
muffler assembly by removing the
factory band clamp on the muffler to
y-pipe connection.
NOTE: Spray lubricant may assist in
hanger pin removal.
4.
Remove the factory tailpipe hanger
pin from the rubber grommet. Remove
the dual rear muffler hanger pins from
Monster Exhaust System Installation
Figure 2