Banks Power Chevy_GMC Trucks: Duramax LLY-LBZ (Diesel ’06 - 07 6.6L) Intake- Ram-Air Intake System '06-07 - Manual (Page 11)

clamps. Attach the turbo intake hose
to the turbo intake tube. Leave the
hose clamps loose.
19.
Install the Banks Ram-Air intake
tube into the Banks bellows. Tighten
all the hose clamps to secure the
Banks intake tube. See Figure 8.
CAUTIoN: Ensure Intake tube is not
touching any engine components.
20.
Fasten the Banks air filter cover
to the Banks air filter housing using
the Banks cover screws and tighten.
21.
Re-attach the MAF sensor
connector to the MAF sensor in the
Banks intake tube.
Note: You may have to loosen the wire
harness clips to increase the slack in
the wiring harness to allow the MAF
connector to reach the MAF sensor in
the Banks intake air tube (Figure 9).
22.
Re-connect battery grounds.
You have successfully completed
the installation of the Banks Ram-Air
Intake system. See Figure 10. Make
sure to check all hose clamps for
tightness and connectors for a sure fit.
Make sure that the intake tube is not
touching any engine components.
Figure 8
96456 v.5.0
11