Banks Power Dodge Trucks: (Diesel ’03 - 07 5.9L Cummins) Tuner- Bullet Diesel Tuner '03-07 235, 250, 305, 325 HP Dodge 5.9L Cummins (24-valve) Trucks - Manual (Page 18)

18
96581 v.7.0
installed in the previous step, then
reinstall the headlight control panel
into the dash. (The control panel should
push easily in and snap back into
place – if it does not, look for kinked or
pinched wiring behind it.) Reinstall the
two Philip head screws if previously
removed in step 8.
11.
2003-2005 trucks Use fuse #50.
See Figure 10
2006-2007 trucks Use fuse #28.
See Figure 12
Remove the fuse box cover, located
in left front side of the engine
compartment. Locate the mini-fuse
applicable to your model year and
remove it (see above). Install the mini-
auto blade tap onto the removed mini
fuse as shown in Figure 9.
Re-install the mini fuse with the
attached blade tap into its previously
removed location.
Note: 2003-2005 trucks Install the
mini-auto blade tap on the terminal leg
closest to the firewall. this is the “hot”
side of the circuit.
2006-2007 trucks Install the mini-auto
blade tap on the terminal leg closest to
the engine. this is the “hot” side of the
circuit.
Caution: It is very important that
you select the proper fuse. The
Banks Bullet Diesel Tuner will
not function properly if installed
incorrectly.
12.
2003-2005 trucks It is
recommended to cut a small notch in
the fuse box cover as shown in Figure
11, to avoid a crimped or stressed wire.
2006-2007 trucks Route the RED
power wire as shown in Figure 12.
All Years Locate the RED wire with the
Power Terminal on the Banks Bullet
Figure 13