Connecting banks automind flash programming module – Banks Power Ford Trucks: (Gas ’99 - 11 6.8L V10; 6.2L V8) AutoMind Flash Programmer for use with Banks iQ Flash User Manual
Page 8
8
97276 v.1.0
2.
certain cellular phones or
radio equipment might also cause
interference, please remove or turn
such devices off.
3.
Unless instructed in the installation
steps, never turn the ignition key
OFF while the Banks AutoMind
Programming Module is plugged into
the AutoMind Flash connector.
WArnInG: Unplugging the
Banks AutoMind Flash
Programming Module while
uploading or downloading a
calibration can damage the
vehicles eCM.
4.
Ensure that the factory “stock”
calibration is in the vehicle’s EcM before
installing the Banks AutoMind Flash
calibration. If you are uncertain if your
vehicle tuning is in stock condition then
have the vehicle’s EcM reflashed by
your vehicle’s make dealer.
NOTE: Dealer re-flashes are the same
as stock factory calibration.
WArnInG: The Banks AutoMind
calibration should noT be installed
over a non-factory/aftermarket
performance tune, and except
in rare cases should not be used
in conjunction with other tuning
devices such as chips or plug in
modules of any kind.
CoMBInInG DeVICeS IS Done AT
THe USer’S oWn rISK
Connecting Banks AutoMind
Flash Programming Module
Locate the OBDII port where you
have plugged in the Banks com-Link
communication Bridge. Loosen the
harness, if previous secured under or
behind the dash, from the OBDII port
to the Banks Bridge Module, enough
to have easy access to the AutoMind
Flash connector. See Figure 1. Plug
Figure 1