Banks Power Chevy_GMC Trucks: Duramax LB7 (Diesel ’01 - 04 6.6L) Exhaust- Monster Exhaust, Split-Dual '01-07 - Manual (Page 9)

24.
Be sure that the two (2) tailpipes
are completely engaged into the
Y-pipe. Rotate the tailpipe until the
hanger pins are parallel with the
frame-mounted pin. Be sure both
tailpipe tips look symmetrical.
NOTE: Minimum distance between
exhaust tip and body is a half ( 1 ⁄
2
) inch.
25.
Using the three (3) supplied wire
ties, tie any hoses, brake lines or
harnesses a minimum of four inches
away from the exhaust/tail pipes.
26.
Tighten the head pipe v-band
clamp to 12 ft-lbs (if previously
loosened).
27.
Align the saddle clamps on the
radius of the corresponding pipe slots.
Figure 3 illustrates the proper location
of an exhaust clamp on a tubing
joint. Torque the nuts on each of the
exhaust clamps to 35 ft-lbs. Torque the
four (4) factory flange nuts, previously
removed, to 30 ft-lbs. Torque the
hanger bracket 1 ⁄
2
” hardware to 65
ft-lbs.
NOTE: If Banks Head pipe was installed,
torque 7 ⁄
16
hardware on 4-bolt flange
and torque to 48 ft-lbs.
28.
Remove the protective covering
from the tailpipe tip.
Caution: the protective covering
may ignite and burn if not removed
prior to running the engine.
29.
Your system includes two (2)
Banks Power decals designed to
complement the Duramax emblems
on the vehicles front doors.
30.
Re-connect the negative battery
cable. Start the engine and listen for
exhaust leaks. Tighten the exhaust
clamps as necessary. Whenever
possible, tack weld slip connections
to prevent disengagement is
recommended.
31.
The Monster exhaust system
installation is now complete.
96439 v.7.0
9