Banks Power Cummins Motorhomes: (Diesel ’03 - 07 ISB-CR 5.9L) Power Pack with EconoMind and Banks iQ w_optional DynaFact Gauges 5.9L (Class-A w_Allison 2000-3000 Trans '03-07), 6.7L (Class-A, All Trans) '07-09 User Manual
Page 25
96828 v.4.0
25
CAUTION: Do not use force
when working on plastic parts.
Permanent damage to the part
might result.
1.
Locate the Window Mount
assembly in your kit.
2.
assemble the Banks iQ docking
station to the Universal mount by
inserting and sliding the Universal
mount tab into the docking station
groove. Hand tighten the nut behind
the docking station to hold the docking
station in place.
3.
attach the window mount to your
Banks iQ. See Figure 20. align and
place the two (2) lower tabs on the
window mount to the corresponding
slots on the bottom of Banks iQ first
then snap the top of Banks iQ into
place.
NOTE: There may be a snug fit when
installing the Banks iQ into the window
mount. Take care not to force this
process.
4.
Find a smooth, flat surface suitable
for ease of access and viewing of
Banks iQ. Loosen the knob and move
the swivel suction plate to achieve
desired viewing angle of the Banks
iQ screen. Do a test fit and note the
angle necessary to achieve the correct
viewing angle.
5.
Make sure the suction cup and the
mounting area on the windshield are
clean and dry. With the suction lever
in the up position, ensure the suction
cup is flat against the windshield, and
then push the suction lever down to
secure in place.
Section 9
Mounting and Connecting the Banks iQ
Figure 20 Attaching Banks iQ to window mount