Banks Power Ford Trucks: (Diesel ’03 - 07 6.0L Power Stroke) Tuner- Bullet Diesel Tuner '03-07 User Manual
Page 18
18
96584 v.5.0
18.
If using a module mounting
method other than the supplied
bracket, complete the mount
installation per the supplied directions.
Double-check all wire harness routing
for proper clearance around moving
and sharp objects as well as heat
sources, then use the supplied nylon
tie straps to secure the wire harnesses
safely away from any control linkages
and the operator’s feet underneath the
dashboard.
19.
Re-attach any previously removed
interior trim panels, re-connect the
negative battery cables and lower the
vehicle. Start the vehicle, checking for
normal engine operation and listening
carefully for exhaust leaks and rattles.
Re-torque any exhaust manifold
fasteners as needed.
NOTE: Go over the entire installation as
a precautionary check to ensure that
all clamps are tight, wiring and hoses
are properly routed, and connections
are correct and tight. Make sure that
the Bullet wire harness is not lying in
the way of the brake and gas pedals,
or any moving parts.
-EnD, SECTIon 2-