Cleaning and oiling the banks ram-air filter – Banks Power Chevy_GMC Trucks: Diesel ’93 - 96 6.5L Power Systems- Stinger System '93-early '94 (non-cat) & '94-up ( w_ cat) Pickups & Suburbans w_ factory turbo option User Manual

Page 14

Advertising
background image

14

cleANiNG ANd oiliNG the BANKs rAM-Air filter

Notification

The Banks Ram-Air Filter comes pre-oiled and no

oiling is necessary for initial installation.

Use Banks ram-Air Filter cleaning system (part

#90094) available from Gale Banks Engineering

to service the Air Filter. Follow the instructions

included with the cleaning system to clean and

re-oil your Banks Ram-Air Filter.

PRE-CLEANING

Tap the element to dislodge

any large embedded dirt, then

gently brush with a soft bristle

brush. nOTe: if complete cleaning

is not practical at this time, reoil

the element and reinstall in your

vehicle.

SPRAY-ON CLEANING

spray Banks air-filter

cleaner liberally onto the

entire element and let

soak for 10 minutes.

PAN CLEANING

large air-filter elements can be

rolled or soaked in a shallow

pan of Banks air-filter cleaner.

remove immediately and

let soak for approximately 10

minutes.

CLEANING HINTS

Use only Banks air-filter cleaner. No gasoline

cleaning, No steam cleaning, No caustic cleaning

solutions, No strong detergents, No high-pressure car

wash, No parts cleaning solvents. any of these Nos

can cause harm to the cotton filter media

plus sHrink and Harden the

rubber end caps.

RINSE OFF

rinse off the element with

low-pressure water. tap

water is okay. always flush from the

clean side to dirty side. This removes

the dirt and does not drive it into the

filter.

DRYING HINTS

always dry naturally. after rinsing, shake off all

excess water and let the element dry naturally. dO nOT

Use coMPressed Air – do Not Use oPeN flAMe –

do Not Use heAt dryers!

excess HeaT Will sHrink THe cOTTOn filTer Media.

coMPressed Air will Blow holes iN the eleMeNt.

AEROSOL OILING

After cleaning air filter always

reoil before using. spray Banks

ram-air filter oil down into

each pleat with one pass

per pleat. Wait 10 minutes

and re-oil any white spots

still showing.

OILING HINTS

never use a banks

ram-air filter without oil (the filter will not stop the dirt

without the oil). use only banks ram-air filter oil. banks

air-filter oil is a compound of mineral and animal oil

blended with special polymers to form a very efficient

tack barrier. red dye is added to show just where

you have applied the oil. eventually the red color will

fade but the oil will remain and filter the air. Never

use automatic Transmission fluid. never use Motor

Oil. never use diesel fuel. never use Wd40, lps, or

other light-weight oils.

REINSTALL

reinstall your banks ram-air filter element with

proper care. Make sure the element seats properly in

the filter case. install the cover making sure it’s in the

right position. Tighten all the nuts, bolts, screws or

clips to factory specifications.

DO NOT DISCARD

affix the “do not discard” sticker to the filter

case (included with every banks replacement element).

Make sure you put the sticker in a highly visible place

to alert your mechanic not to discard.

PERFORMANCE HINTS

service every 50-100,000 miles on street-driven

applications. service more often in offroad or heavy-dust

conditions. if an air-filter restriction gauge is installed,

then change the element when the air-filter restriction

reaches 18”/H

2

o.

CAUTION! extremely fine dust from agriculture or

offroad use will pull the oil from the element. frequent

reoiling of the element’s clean side might be required.

completely service when practicable. for extra

protection use an air-filter sealing grease on rubber

ends of the element. service only with banks air-filter

cleaner and banks air-filter oil.

6.

7.

8.

9.

10.

1.

2.

3.

4.

5.

p.n. 96309 v.3.0

Advertising