Banks Power GM Motorhomes: (Gas ’01 - 10 8.1L Workhorse) PowerPack &Stinger systems '00-07 Class-A MH, W-series - Manual (Page 10)

tailpipe is inserted fully into
the slip joint of the muffler and
tighten the clamp.
38.
Slide the tailpipe tip onto
the tailpipe extension. Position
the tip so it extends 1-inch
beyond the coach body or
wherever aesthetically pleasing
and tighten the band-clamp.
BaNKS RaM-aIR™
FILTER:
39.
Locate the factory air filter
housing and access it from
inside the right-side wheel-
well. Replace the factory air
filter element with Banks Ram
air element. Place the “STOP!”
decal on the air filter housing
so that it is clearly visible to
service personnel.
40.
Re-install the inner front
fender shields and wheels
if removed. Make sure to
torque the wheels to the
manufacturer’s specifications.
Lower the vehicle and
reconnect the battery cables.
Start the engine and listen for
any exhaust leaks. Tighten
bolts or clamps to correct any
leaks or improper adjustments.
Whenever possible, tack-
welding slip connections to
prevent disengagement is
recommended.
Note: It is normal for the
vehicle exhaust to smoke upon
initial start-up. This indicates
the lubricant applied during
the tube-bending process is
burning off the pipes.
10 |
9 6 4 3 1 v . 7 . 0