Banks Power Dodge Trucks: (Diesel ’07 - 12 6.7L Cummins) Exhaust- Monster Exhaust ('07-10), Single Passenger side exit Including Mega Cab - Manual (Page 6)

6
96465 v.6.0
Figure 2
Cut line
See Table 1 for cutting length
10.
With everything positioned
properly, begin to tighten the clamps
starting with the ones closest to the
turbo and working your way back.
Evenly torque the exhaust clamps to
35 ft-lbs. Make sure that each slip is
fully inserted (+/- 1 ⁄
4
inch).
11.
Remove the protective covering
from the tailpipe tip.
CAUTION: The protective covering
may ignite and burn if not removed
prior to running the engine.
12.
your system includes two (2)
Banks power logos. The logos can
be mounted 1 ⁄
2
” to 1” above the
“cummins Turbo Diesel” emblem on
the driver-side and passenger-side
front fenders.
13.
Re-connect battery terminals if
previously removed. Banks Monster
Exhaust installation is now complete.
2007-2010 Dodge 6.7L Cummins
Wheel Base
2007-2009
cut this length from the
Intermediate Pipe. See Figure 2.
Mega cab/ Short Bed 160.5” No cut
Quad cab/ Long Bed 160.5” No cut
Quad cab/ Short Bed 140.5” 21.75”
Regular cab/ Long Bed 140.5” 21.75”
Wheel Base
2010
cut this length from the
Intermediate Pipe.
Quad cab/ Short Bed 149.5” 21.75”
Table 1