Monster exhaust system installation – Banks Power Ford Trucks: (Diesel ’11 - 14 6.7L Power Stroke) Exhaust- Monster Exhaust, Dual-Tip Passenger side exit '11 F-250_F-350 CCLB User Manual
Page 6
6
96542 v.3.0
Monster Exhaust System Installation
1.
As a precaution, disconnect the
ground of the battery (if there is more
than one battery, disconnect both).
2.
Raise the vehicle and support it with
properly weight rated safety stands,
ramps or a commercial hoist. Follow
the manufacturer’s safety precautions.
Take care to balance the vehicle to
prevent it from slipping or falling. When
using ramps, be sure the front wheels
are centered squarely on the topsides;
place the transmission in park; set the
parking brake and place blocks behind
the rear wheels.
CauTIoN: Do NoT WoRK uNDER
aNY VEHICLE SuPPoRTED oNLY
BY a JaCK. SEVERE INJuRY MaY
RESuLT.
WaRNING! The following step may
require the use of a torch and/
or saw. Proper safety equipment
should be used. Failure to use
proper safety equipment may
result in severe injury.
3.
Removal of the factory exhaust can
be simplified by cutting the factory
exhaust pipe behind the muffler. This
will allow the tailpipe to be removed
as a separate piece.
4.
Remove the factory tailpipe from
the vehicle by disengaging the exhaust
system hanger pins from the rubber
hangers using a large screw-driver or
pry bar.
Note: Lubricating the rubber hangers
with WD-40 or similar lubricant will
ease removal of the hanger pins.
5.
Remove the factory muffler from
the vehicle by removing the three (3)
nuts from the factory exhaust flange
located at the factory muffler inlet.
6.
For CCSB Models oNLY, locate
the supplied banks intermediate pipe
and cut 17” off the non-flange side of
the pipe as shown in Figure 2.
7.
Install the Banks intermediate pipe
and 3-bolt gasket onto the headpipe.
Loosely assemble with the supplied
bolts, washers, and nuts.
8.
Slide the supplied 4” exhaust
hanger clamp onto the outlet of the
Banks flanged intermediate pipe so
that the hanger pins point to the rear
of the vehicle. Insert the hanger pin
into the factory rubber hanger.
Figure 2 For CCSB Models oNLY
Measure 17 inches from
the rear (non-flange)
end of pipe.
Cut Line