Banks Power Jeep Trucks: (Gas ’07 - 11 3.8L) Intake- Ram-Air Intake System '07-09 Jeep 3.8L User Manual
Page 6
6
96576 v.2.0
Use the Bill of Materials Chart and
the General Assembly Drawing to
reference component nomenclature
and location. Use caution when
working in the engine compartment.
Make sure the engine has been OFF
for several hours and cool.
You are about to install the Banks
Ram-Air Intake System. Read and
follow all steps before working on the
vehicle. Some components from the
stock air intake system will remain
in service. Take care when removing
stock air intake components to not
damage them.
1.
Disconnect and remove the Air
Intake Temperature (AIT) Sensor
located on the intake tube by moving
the red tab back and pulling the
connector. Set connector aside and
retain sensor for re-use. See Figure 2.
Note: Take care when handling the
sensor.
2.
Disconnect the CCV hose from the
air intake tube by moving spring clamp
away from joint. Retain for re-use.
3.
Loosen both air intake hose clamps
and remove the air intake tube from
the engine compartment. See
Figure 3.
4.
Un-clip the four tabs holding the
air filter housing cover. Remove the
cover and the air filter from the engine
compartment and set aside.
5.
Remove the air filter housing
(bottom) by lifting up from the
passenger side of the engine
compartment and set aside. See
Figure 4.
6.
Install the 3 three (supplied)
Mounting Pegs onto the Banks air filter
housing so that they extend out of the
housing and then attach the E-Clips
onto the three Mounting Pegs from the
outside of the housing. See figure 5.
Section 2
RAM-AIR INSTALLATION
Figure 2- Removal of AIT sensor