Banks Power Ford Trucks: (Diesel ’08 - 10 6.4L Power Stroke) Exhaust- Monster Exhaust, Split-Dual Quad-Tip '08-10 F-250_ F-350 - Manual (Page 10)

10
96547 v.4.0
11.
The vehicle spare tire will have
to be removed to install the Dual
Tailpipes. Using the manufacturer
tire tools, remove the spare tire and
secure the spare tire hoist cable.
12.
Remove the heat shield located by
the stock spare tire location.
13.
Locate the two slots on the rear
driver-side frame rail and install the
supplied Banks hanger bracket using
the supplied hardware. Be sure the
hanger pin is align parallel to the frame
rail and torque the hardware to 48ft-lb.
See Figure 4.
14.
Install the supplied rubber
insulator onto the Banks hanger
bracket.
15.
Install the driver-side tailpipe onto
the left Y-pipe outlet. Install the driver-
side tailpipe hanger into the vehicle
rubber insulator. Position the rubber
insulator as shown in Figure 5.
16.
Install the passenger-side tailpipe
onto the right Y-pipe outlet. Install the
passenger-side tailpipe hanger into the
vehicle rubber insulator. Position the
rubber insulator as shown in Figure 3.
17.
Adjust the Tailpipe Tips under the
rear fender such that the tip position is
aesthetically pleasing.
18.
Use Template 1 and/or 2
on page 14 & 15 to trim the rear
undercarriage fender lining as shown
in Figure 6 for the LEFT and RIGHT
side of the vehicle.
FACTORY
LEAF STOP BANKS
HANGER
BRACKET
FACTORY
FRAME
SLOT
BANKS
RUBBER
INSULATOR
BANKS
7/16”
HARDWARE
BANKS
DRIVER SIDE
TAILPIPE
FORWARD
Figure 4