Banks Power 2001-2007 (LB7, LLY & LBZ) Chevy_GMC 6.6L Duramax Turbo-Diesel Pickups - Manual (Page 6)

Note: On extended-cab long-bed and
crew-cab long-bed vehicles, the clamp
that is used between the intermediate
pipe and muffler is a combination
hanger/clamp. When this hanger clamp
is installed the hanger pin should be
inserted into the factory rubber hanger
and the clamp should be rotated until
the hanger pin is parallel with the frame
mounted pin before being torqued.
17.
Install the muffler onto the end
of the intermediate pipe outlet. Be
sure that the inlet side of the muffler
(see markings on muffler body)
is facing toward the front of the
vehicle. Orient the muffler such that
the “Banks Monster” logo is facing
towards the frame and is level with
the ground. verify that the muffler
and intermediate pipe are completely
engaged.
18.
Slide one (1) of the supplied
4” exhaust clamps onto the Banks
Monster muffler outlet.
19.
Install the tailpipe into the outlet
of the muffler. Be sure that the two
pipes are completely engaged. Insert
the front and rear tailpipe hanger pins
into the factory rubber hangers. Rotate
the tailpipe until the hanger pins are
parallel with the frame mounted pin.
NOTE: Minimum distance between
exhaust tip and body is one (1) inch.
20.
Tighten the head pipe v-band
clamp to 12 ft-lbs (if previously
loosened).
21.
Adjust each of the pipes to ensure
that all of the hanger pins are parallel
with the frame mounted pins and that
the rubber hangers are all positioned
slightly forward (See Figure 3). The
amount of forward angle on the rubber
hangers should increase the farther
downstream the hanger is positioned.
This allows the hangers to be properly
positioned once the exhaust system
reaches operating temperature.
22.
Install the exhaust clamp at
each of the three (3) joints. Figure
4 illustrates the proper location of
an exhaust clamp on a tubing joint.
Torque the nuts on each of the
Figure 3
6
96408 v.9.0