Tap/cv input, Control voltage – Moog Music 500 Series Analog Delay User Manual

Page 14

Advertising
background image

14

TAP/CV INPUT

TAP TEMPO

The

TAP TEMPO input on the Analog Delay can be used to control either

the

DELAY TIME or the LFO RATE.

SET A TEMPO: Simply plug in a Moog FS-1 footswitch and tap at the de-
sired tempo in quarter notes. After the third tap the Delay will begin calcu-
lating the tempo and keep the average tempo as you continue to tap.

SET A NEW TEMPO: Wait five seconds and then press the switch three
times to set a new tempo.

CHANGE TAP TEMPO DESTINATION: use the TAP TEMPO DESTINATION
control on the plugin/stand-alone editor, or press and hold the tap tempo
footswitch to toggle between

DELAY TIME and LFO RATE. The destina-

tion LED (

DELAY TIME or LFO RATE) will flash green one time to indicate

the destination. The LED indicator for the function being controlled by Tap
Tempo will flash green and in sync with the chosen tempo

NOTE: When either destination is synchronized to MIDI Clock, Tap Tempo is
disabled.

LFO EFFECTS ON DELAY TIME SET USING TAP TEMPO

If you set the

DELAY TIME via Tap Tempo and then modulate the TIME with

the LFO, you may find that your tapped tempo has changed. This is due to
the LFO averaging the

DELAY TIME.

CONTROL VOLTAGE

DELAY TIME: A setting of 0 volts or GROUND sets the DELAY TIME to the
shortest possible time while a 5v setting sets the

TIME to the longest pos-

sible time, based on the current 0.5x/1.0x and

TIME MULTIPLIER settings.

To modify the

DELAY TIME from minimum to maximum via control voltage

or expression pedal, set the

DELAY TIME control to the lowest setting via

the panel, editor or MIDI message.

FEEDBACK: A setting of 0 volts or GROUND allows for no feedback while
a 5v setting gives infinite feedback. To change the

FEEDBACK amount

from zero to infinite via control voltage or expression pedal, set the

FEED-

BACK to the lowest setting via the panel, editor or MIDI message.

LFO RATE – A setting of 0 volts or GROUND sets LFO Rate to 5 Hz while a
5v setting sets the

RATE to 50 Hz. To modify the LFO RATE from minimum

to maximum via control voltage or expression pedal, set the

LFO RATE to

the lowest setting via the editor or MIDI message.

Advertising