Cobalt Digital COMPASS 9002 3G_HD_SD Distribution Amplifier (Non-Reclocking) - Manual (Page 11)

9002 Owner’s Manual •••• (V 1.8) Page 11
Cable Connections
This section provides instructions for connecting cables to the installed BNC rear modules. Connect the
input and output cables according to the following diagram. Split rear module RM20-9002-A/S and
RM20-9002-B/S allow two cards to be installed in adjacent slots. B/S versions are available in
DIN1.0/2/3 and HDBNC versions.
RM20-9002-A RM20-9002-A/S RM20-9002-B/S
Note:
Early versions of 9002 have some outputs as inverting. These outputs are not compatible with
ASI video. Please contact product support and have card serial number on hand for more information.
Figure 3. Connector Designations for the Card Rear Modules