Rear module installation – Cobalt Digital COMPASS 9252 AES Audio Distribution Amplifier, 110 Ohms User Manual
Page 9
9
Rear Module Installation
If you are installing the card into a slot with no rear module, you should have ordered and received one
of the RM-9252-A module. You will need to install it in your 8310 frame before you can connect
cables.
Use the following steps to install a rear module in an 8310 openGear
TM
frame:
1.
Refer to the openGear
TM
8310 frame Owner’s Manual, to ensure that the frame is
properly installed according to instructions.
2.
On the rear of the 8310, locate the card frame slot.
3.
As shown in Figure 2, seat the bottom of the rear module in the seating slot at the
base of the frame’s back plane.
Figure 2. Rear Module Installation
4.
Align the top hole of the RM-9252-A with the screw hole on the top edge of the 8310
back plane.
5.
Using a Phillips driver and the supplied screw, fasten the rear module to the 8310
back plane. Do not over tighten.
All modules are installed using the same method above.
The following section contains a drawing of the RM-9252-A module.