Cobalt Digital COMPASS 9242 Analog Audio Distribution Amplifier with Remote Gain Control - Manual (Page 18)

2-4
• Installation
9242 Product Manual (V1.1)
Installing the 9242
This section outlines how to install the 9242 in a 20-Slot series frame. If the 9242 is to be installed in
any compatible frame other than a Cobalt Digital product, refer to the frame manufacturer’s manual for
specific instructions.
Use the following procedure to install the 9242 in a 20-Slot series frame:
1. Locate the Rear Module you installed in the procedure “Installing a Rear Module”.
2. Hold the 9242 by the edges and carefully align the card edges with the slots in the frame.
3. Fully insert the card into the frame until the rear connection plugs are properly seated on
the midplane and rear module.
4. Verify whether your label is self-adhesive by checking the back of the label before
applying the label to the rear module surface.
5. Affix the supplied Rear Module Label to the BNC area of the Rear Module.