Card status leds, Factory default settings – Cobalt Digital COMPASS 9021 Standard Definition A_D Analog Composite, Y_C, Component to 10-bit SDI User Manual
Page 15
Advertising
9021 Owner’s Manual
••••
(V 1.1)
Page 15 of 22
Card Status LEDs
The card LEDs report the lock status of the device. See the table below for an explanation of each
function.
LED NAME
DESCRIPTION
LOCK LED
Flashes green when not locked to input signal. When locked illuminates steady
green. When S3 or S4 not at 0, indicates state of parameter.
NTSC LED
On when locked to NTSC input, off otherwise
PAL LED
On when locked to PAL input, off otherwise
RMT LED
reserved for future use
Factory Default Settings
The factory default settings are as follows
1)
S4 - Color is On
2)
S5 – Test Pattern is Off
3)
S6 – Setup is On
4)
S7 – Output Sample Mode is 16:16:16
5)
S8 – De-Jitter Filter is On
Advertising