Cobalt Digital COMPASS 9035 Analog and SDI Input to SDI Output Converter - Manual (Page 43)

9035-OM (V4.4) 9035 PRODUCT MANUAL 2-11
Installation and Setup
Setting Up 9035 Network Remote Control
Setting Up 9035 Network Remote Control
Perform remote control setup in accordance with Cobalt ® reference guide
“COMPASS™ Remote Control User Guide” (PN 9000RCS-RM).
Note: • If network remote control is to be used for the frame and the frame has not
yet been set up for remote control, Cobalt ® reference guide “COMPASS™
Remote Control User Guide” (PN 9000RCS-RM) provides thorough informa-
tion and step-by-step instructions for setting up network remote control of
COMPASS™ cards using DashBoard™. (Cobalt
® OGCP-9000 and
OGCP-9000/CC Remote Control Panel product manuals have complete
instructions for setting up remote control using a Remote Control Panel.)
Download a copy of this guide by clicking on the DashBoard Control and
Monitoring link at www.cobaltdigital.com and then select DashBoard
Remote Control Manual as a download, or contact Cobalt
® as listed in Con-
tact Cobalt Digital Inc. (p. 1-28).
• If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.