Rf-tvmfm01v2 tv wall mount, You’ll need – RocketFish RF-TVMFM01 - User Manual User Manual
Page 9
9
Need help? Call 1-800-620-2790 (U.S. and Canada) or 01-800-926-3010 (Mexico)
RF-TVMFM01V2 TV Wall Mount
STEP 5 - Option 1: Attaching the hardware and mounting the TV to the arm assembly
for TVs with a flat back
1
Install washers (D), and screws (B) into the top two holes in the back of the TV.
2
Leave a gap between the back of the TV and the washer and screw.
3
Mount the TV by fitting the top screws and washers over the notches in the top of the arm assembly plate.
4
Install the bottom screws (B) and washers (D) into the bottom holes. If the hole pattern on your TV is 75mm
x 75mm, do not use washers.
5
Make sure that the bracket is level, then tighten all screws carefully until snug.
You’ll need
HEAVY! You will need
assistance with this step.
D (4)
B (4)
Phillips screwdriver
Screws
Washers
Level
Arm assembly (A)
RF-TVMFM01V2_13-0599_MAN_V4_ENG - GIFs.fm Page 9 Friday, June 28, 2013 8:10 AM