Play mode & edit mode, Editing – TC Electronic G-System User Manual

Page 33

Advertising

Editing

Editing G-System presets is quite simple.

Editing Presets in Play Mode
•

Activate/deactivate loops and effects simply by
pressing the corresponding switches. When a switch
is lit, the corresponding function is active.

Effects with no dedicated switch, Loop 4 and the Insert
loop are activated/deactivated in Edit Mode.

Editing Presets in Effects Edit Mode
In this mode, you set up the various effect parameters.

•

Press EDIT.

•

Select which effect to edit by turning PAGE and
pressing ENTER.

•

Parameters are organized in pages of three. Select a
parameter page using PAGE.

•

Edit the shown parameters using encoders A, B and C.

Example

>> EFFECT COPIED <<

EDIT A

EDIT B

EDIT C

>> PRESET STORED <<

EDIT A

EDIT B

EDIT C

: Relay

EDIT A

EDIT B

EDIT C

0C00

: 0C0C :

EDIT A

0C00

Fast Access to Effect Parameters
If the effect you wish to access has a switch
assigned to it, the parameters are easily
accessed simply by pressing EDIT, followed by
the assigned switch.
Example: Press EDIT and then REVERB to
access reverb parameters.

Selecting Effect Types
Each effect block includes several different subtypes of
effects. As an example the Delay block includes: Single
Delay, Tape Delay, Reverse, Lo-Fi, Pingpong, Dynamic
and Dual Delay.
Selecting the Effect type is part of the Effects Edit mode.

•

Press EDIT to enter Edit mode.

•

Select effect block using the PAGE encoder and
press ENTER.

•

Turn the PAGE encoder one click counter-clockwise.

•

Select the wanted effect type using encoder C.

•

Press ENTER.

Loops Status
•

Press EDIT and any of the three LOOP switches.

•

Use PAGE to select the Loop page.

•

Set loops on or off using encoders A, B and C.

PLAY MODE & EDIT MODE

Advertising