Rainbow Electronics T89C51CC01 User Manual

Enhanced 8-bit mcu with can controller and flash, Features

Advertising

Table of contents

Document Outline

1. Features
2. Description
3. Block Diagram
4. Pin Configuration
- 4.2 I/O Configurations
- 4.3 Port 1, Port 3 and Port 4
- 4.4 Port 0 and Port2
- 4.5 Read-Modify-Write Instructions
- 4.6 Quasi-Bidirectional Port Operation
5. SFR Mapping
6. Clock
- 6.1 Description
- 6.2 Register
7. Data Memory
- 7.1 Internal Space
- 7.2 External Space
- 7.3 Dual Data Pointer
- 7.4 Registers
8. EEPROM Data Memory
- 8.1 Write Data in the column latches
- 8.2 Programming
- 8.3 Read Data
- 8.4 Examples
- 8.5 Registers
9. Program/Code Memory
- 9.1 External Code Memory Access
- 9.2 FLASH Memory Architecture
- 9.3 Overview of FM0 operations
- 9.4 Registers
10. In-System- Programming (ISP)
- 10.1 Flash Programming and Erasure
- 10.2 Boot Process
- 10.3 Application- Programming-Interface
- 10.4 XROW Bytes
- 10.5 Hardware Security Byte
11. Serial I/O Port
- 11.1 Framing Error Detection
- 11.2 Automatic Address Recognition
- 11.3 Given Address
- 11.4 Broadcast Address
- 11.5 Registers
12. Timers/Counters
- 12.1 Timer/Counter Operations
- 12.2 Timer 0
- 12.3 Timer 1
- 12.4 Interrupt
- 12.5 Registers
13. Timer 2
- 13.1 Auto-Reload Mode
- 13.2 Programmable Clock-Output
- 13.3 Registers
14. WatchDog Timer
- 14.1 WatchDog Programming
- 14.2 WatchDog Timer during Power down mode and Idle
15. Atmel CAN Controller
- 15.1 CAN Controller Description
- 15.2 CAN Controller Mailbox and Registers Organization
- 15.3 CAN Controller management
- 15.4 IT CAN management
- 15.5 Bit Timing and BaudRate
- 15.6 Fault Confinement
- 15.7 Acceptance filter
- 15.8 Data and Remote frame
- 15.9 Time Trigger Communication (TTC) and Message Stamping
- 15.10 CAN Autobaud and Listening mode
- 15.11 Routines Examples
- 15.12 CAN SFR’s
- 15.13 Registers
16. Programmable Counter Array PCA
- 16.1 PCA Timer
- 16.2 PCA modules
- 16.3 PCA Interrupt
- 16.4 PCA Capture Mode
- 16.5 16-bit Software Timer Mode
- 16.6 High Speed Output Mode
- 16.7 Pulse Width Modulator Mode
- 16.8 PCA Watchdog Timer
- 16.9 PCA Registers
17. Analog-to-Digital Converter (ADC)
- 17.1 Features
- 17.2 ADC Port1 I/O Functions
- 17.3 ADC Converter Operation
- 17.4 Voltage Conversion
- 17.5 Clock Selection
- 17.6 ADC Standby Mode
- 17.7 IT ADC management
- 17.8 Routines examples
- 17.9 Registers
18. Interrupt System
- 18.1 Introduction
- 18.2 Registers
19. Electrical Characteristics
- 19.1 Absolute Maximum Ratings (1)
- 19.2 DC Parameters for Standard Voltage
- 19.3 DC Parameters for A/D Converter
- 19.4 AC Parameters
20. Ordering Information
Table of Contents