2 features, Features, Nuc140 series data sheet – Rainbow Electronics NUC140 User Manual

Page 6

Advertising
background image

NUC140 Series DATA SHEET

Publication Release Date: May 31, 2010

- 6 -

Revision V1.02

2

FEATURES

• Core

–

ARM® Cortex™-M0 core runs up to 50MHz.

–

One 24-bit system timer.

–

Supports low power sleep-mode.

–

Single-cycle 32-bit hardware multiplier.

–

NVIC for the 32 interrupt inputs, each with 4-levels of priority.

–

Serial Wire Debug supports with 2 watchpoints/4 breakpoints.

•

Wide operating voltage ranges from 2.5V to 5.5V

•

Flash EPROM Memory

–

64K/128K bytes Flash EPROM for program code.

–

4kB flash for ISP loader

–

Support In-system program(ISP) and In-application program(IAP) application code update

–

512 byte page erase for flash

–

Configurable data flash address and size for 128kB system, fixed 4kB data flash for 64kB
system.

–

Support 2-wire ICP update from ICE interface

–

Support fast parallel programming mode by external programmer.

• SRAM

Memory

–

8K/16k bytes embedded SRAM.

–

Support PDMA mode

• PDMA

(Peripheral

DMA)

–

Support 9 channels PDMA for automatic data transfer between SRAM and peripherals.

• Clock

Control

–

Flexible selection for different applications.

–

Build-in 22MHz OSC (Trimmed to 1%) for system operation, and low power 10KHz OSC for
watchdog and wakeup sleep operation.

–

Support one PLL, up to 50MHz, for high performance system operation.

–

External 12MHz crystal input for USB and precise timing operation.

–

External 32 kHz crystal input for RTC function and low power system operation.

• GPIO

–

Four I/O modes:

‹

Quasi bi-direction

‹

Push-Pull output

‹

Open-Drain output

‹

Input only with high impendence

–

TTL/Schmitt trigger input selectable.

–

I/O pin can be configured as interrupt source with edge/level setting.

–

High driver and high sink IO mode support.

Advertising