Pin description – Rainbow Electronics MAX4884 User Manual

Page 6

Advertising
background image

MAX4881–MAX4884

Overvoltage Protection Controllers with
Current Limit in TDFN

6

_______________________________________________________________________________________

Pin Description

PIN

NAME

FUNCTION

1

IN

Input. IN is the power input for the OVP charge pump. Bypass IN to GND with a 1µF capacitor or
larger.

2

EN

Active-Low Enable Input. Drive

EN high to turn off the external MOSFET. Driving EN low activates

the OVP circuitry and turns on the external MOSFET.

3

GATE

Gate Drive Output. GATE is the output of an on-chip OVP charge pump. When V

UVLO

< V

IN

<

V

OVLO

, GATE is driven high to turn on the external n-channel MOSFET.

4

BTA

Internal Current-Limited Switch Terminal. Connect BTA to the source of the external n-channel
MOSFET. BTA is the power input for the entire device (except the OVP charge pump). Bypass BTA
to GND with a 0.1µF capacitor as close to the device as possible for proper operation.

5

CB

Active-Low Internal Current-Limited-Switch Control Input. Drive CB high to turn on the internal
switch, pull CB low to turn off the internal switch.

6

GND

Ground

7

BTB

Internal Current-Limited-Switch Output. Bypass BTB to GND with 0.1µF capacitor as close to the
device as possible.

8

FLAGI

Active-Low Open-Drain Internal Current-Limited Flag Output.

FLAGI asserts low when the current

is at the limit for longer than the blanking time.

FLAGI is disabled when EN goes high.

9

N.C.

No Connection. Not internally connected.

10

OV

Active-Low Open-Drain IN-Overvoltage Flag Output.

OV goes low when an

undervoltage/overvoltage fault occurs at IN.

OV is disabled when EN goes high.

—

EP

Exposed Pad. EP is internally connected to GND. Do not use EP as the only electrical ground
connection.

Advertising