Adc - analog to digital converter, 1 features, 2 overview – Rainbow Electronics ATtiny861_V User Manual

Page 142: Adc – analog to digital converter” on, Adc – analog to digital converter

Advertising
background image

142

2588B–AVR–11/06

ATtiny261/461/861

19. ADC – Analog to Digital Converter

19.1

Features

•

10-bit Resolution

•

1.0 LSB Integral Non-linearity

•

± 2 LSB Absolute Accuracy

•

65 - 260 µs Conversion Time

•

Up to 15 kSPS at Maximum Resolution

•

11 Multiplexed Single Ended Input Channels

•

16 Differential input pairs

•

15 Differential input pairs with selectable gain

•

Temperature sensor input channel

•

Optional Left Adjustment for ADC Result Readout

•

0 - V

CC

ADC Input Voltage Range

•

Selectable 1.1V / 2.56V ADC Voltage Reference

•

Free Running or Single Conversion Mode

•

ADC Start Conversion by Auto Triggering on Interrupt Sources

•

Interrupt on ADC Conversion Complete

•

Sleep Mode Noise Cancele

•

Unipolar / Bibolar Input Mode

•

Input Polarity Reversal Mode

19.2

Overview

The ATtiny261/461/861 features a 10-bit successive approximation ADC. The ADC is connected
to a 11-channel Analog Multiplexer which allows 16 differential voltage input combinations and
11 single-ended voltage inputs constructed from the pins PA7..PA0 or PB7..PB4. The differential
input is equipped with a programmable gain stage, providing amplification steps of 1x, 8x, 20x or
32x on the differential input voltage before the A/D conversion. The single-ended voltage inputs
refer to 0V (GND).

The ADC contains a Sample and Hold circuit which ensures that the input voltage to the ADC is
held at a constant level during conversion. A block diagram of the ADC is shown in

Figure 19-1

.

Internal reference voltages of nominally 1.1V or 2.56V are provided On-chip. The Internal refer-
ance voltage of 2.56V, can optionally be externally decoupled at the AREF (PA3) pin by a
capacitor, for better noise performance. Alternatively, V

CC

can be used as reference voltage for

single ended channels. There is also an option to use an external voltage reference and turn-off
the internal voltage reference. These options are selected using the REFS2:0 bits of the ADMUX
control register.

Advertising