Rainbow Electronics AT89LS53 - Manual (Page 21)

AT89LS53
4-269
Flash Parallel Programming Modes
Notes: 1. “h” = weakly pulled “High” internally.
2. Chip Erase and Serial Programming Fuse require a 10-ms PROG pulse. Chip Erase needs to be performed first before
reprogramming any byte with a content other than FFH.
3. P3.4 is pulled Low during programming to indicate RDY/BSY.
4. “X” = don’t care
Mode RST PSEN ALE/PROG EA/V
PP
P2.6 P2.7 P3.6 P3.7
Data I/O
P0.7:0
Address
P2.5:0 P1.7:0
Serial Prog. Modes H h
(1)
h
(1)
x
Chip Erase H L 12V H L L L X X
Write (12K bytes) Memory H L 12V L H H H DIN ADDR
Read (12K bytes) Memory H L H 12V L L H H DOUT ADDR
Write Lock Bits: H L 12V H L H L DIN X
Bit - 1 P0.7 = 0 X
Bit - 2 P0.6 = 0 X
Bit - 3 P0.5 = 0 X
Read Lock Bits: H L H 12V H H L L DOUT X
Bit - 1 @P0.2 X
Bit - 2 @P0.1 X
Bit - 3 @P0.0 X
Read Atmel Code H L H 12V L L L L DOUT 30H
Read Device Code H L H 12V L L L L DOUT 31H
Serial Prog. Enable H L 12V L H L H P0.0 = 0 X
Serial Prog. Disable H L 12V L H L H P0.0 = 1 X
Read Serial Prog. Fuse H L H 12V H H L H @P0.0 X
(2)
(2)
(2)