Rainbow Electronics ATA5746 User Manual

Features, Applications, Benefits

Advertising
background image

Features

•

Transparent RF Receiver ICs for 315 MHz (ATA5746) and 433.92 MHz (ATA5745) With

High Receiving Sensitivity

•

Fully Integrated PLL With Low Phase Noise VCO, PLL, and Loop Filter

•

High FSK/ASK Sensitivity:–105 dBm (ATA5746, FSK, 9.6 Kbits/s, Manchester, BER 10

-3

)

–114 dBm (ATA5746, ASK, 2.4 Kbits/s, Manchester, BER 10

-3

)

–104 dBm (ATA5745, FSK, 9.6 Kbits/s, Manchester, BER 10

-3

)

–113 dBm (ATA5745, ASK, 2.4 Kbits/s, Manchester, BER 10

-3

)

•

Supply Current: 6.5 mA in Active Mode (3V, 25°C, ASK Mode)

•

Data Rate: 1 Kbit/s to 10 Kbits/s Manchester ASK, 1 Kbit/s to 20 Kbits/s Manchester

FSK With Four Programmable Bit Rate Ranges

•

Switching Between Modulation Types ASK/FSK and Different Data Rates Possible in
≤1 ms Typically, Without Hardware Modification on Board to Allow Different Modulation
Schemes for RKE, TPMS

•

Low Standby Current: 50 µA at 3V, 25°C

•

ASK/FSK Receiver Uses a Low-IF Architecture With High Selectivity, Blocking, and

Low Intermodulation (Typical 3-dB Blocking 68.0 dBC at ±3 MHz/74.0 dBC at

±20.0 MHz, System I1dBCP = –31 dBm/System IIP3 = –24 dBm)

•

Telegram Pause Up to 52 ms Supported in ASK Mode

•

Wide Bandwidth AGC to Handle Large Out-of-band Blockers above the System I1dBCP

•

440-kHz IF Frequency With 30-dB Image Rejection and 420-kHz IF Bandwidth to

Support PLL Transmitters With Standard Crystals or SAW-based Transmitters

•

RSSI (Received Signal Strength Indicator) With Output Signal Dynamic Range of 65 dB

•

Low In-band Sensitivity Change of Typically ±2.0 dB Within ±160-kHz Center

Frequency Change in the Complete Temperature and Supply Voltage Range

•

Sophisticated Threshold Control and Quasi-peak Detector Circuit in the Data Slicer

•

Fast and Stable XTO Start-up Circuit (> –1.4 k

Ω Worst-case Start Impedance)

•

Clock Generation for Microcontroller

•

ESD Protection at all Pins (±4 kV HBM, ±200V MM, ±500V FCDM)

•

Dual Supply Voltage Range: 2.7V to 3.3V or 4.5V to 5.5V

•

Temperature Range: –40°C to +105°C

•

Small 5 mm

× 5 mm QFN24 Package

Applications

•

Automotive Keyless Entry and Tire Pressure Monitoring Systems

•

Alarm, Telemetering and Energy Metering Systems

Benefits

•

Supports Header and Blanking Periods of Protocols Common in RKE and TPM

Systems (Up to 52 ms in ASK Mode)

•

All RF Relevant Functions are Integrated. The Single-ended RF Input is Suited for Easy

Adaptation to

λ

/ 4 or Printed-loop Antennas

•

Allows a Low-cost Application With Only 8 Passive Components

•

Suitable for use in a Receiver for Joint RKE and TPMS

•

Optimal Bandwidth Maximizes Sensitivity while Maintaining SAW Transmitter

Compatibility

•

Clock Output Provides an External Microcontroller Crystal-precision Time Reference

•

Well Suited for Use With PLL Transmitter ATA5756/ATA5757

UHF ASK/FSK
Receiver

ATA5745
ATA5746

Preliminary

4596A–RKE–05/06

Advertising