Rainbow Electronics MAX1207 - Manual (Page 15)

MAX1207
65Msps, 12-Bit ADC
______________________________________________________________________________________ 15
OFFSET ERROR
vs. TEMPERATURE
MAX1207 toc36
TEMPERATURE (°C)
OFFSET ERROR (%FS)
60 35 10 -15
-0.26
-0.22
-0.18
-0.24
-0.20
-0.16
-0.14
-0.12
-0.28
-40 85
V REFIN = 2.048V
GAIN ERROR
vs. TEMPERATURE
MAX1207 toc37
TEMPERATURE (°C)
GAIN ERROR (%FR)
60 35 10 -15
0.10
0.20
0.30
0.15
0.25
0.35
0.40
0
-40 85
V REFIN = 2.048V
Pin Description
PIN NAME FUNCTION
1 REFP
Positive Reference I/O. Conversion range is ±(V REFP - V REFN ). Bypass REFP to GND with a 0.1µF
capacitor. Connect a 1µF capacitor in parallel with a 10µF capacitor between REFP and REFN.
2 REFN
Negative Reference I/O. Conversion range is ±(V REFP - V REFN ). Bypass REFN to GND with a 0.1µF
capacitor. Connect a 1µF capacitor in parallel with a 10µF capacitor between REFP and REFN.
3 COM
Common-Mode Voltage I/O. Bypass COM to GND with a ≥2.2µF capacitor in parallel with a 0.1µF
capacitor.
4, 7, 16, 35 GND Ground. Connect all ground pins and the EP together.
5 INP
Positive Analog Input. For single-ended input operation, connect signal source to INP and connect INN
to COM. For differential operation, connect the input signal between INP and INN.
6 INN
Negative Analog Input. For single-ended input operation, connect INN to COM. For differential operation,
connect the input signal between INP and INN.
8 DCE
Duty-Cycle Equalizer Input. Connect DCE low (GND) to disable the internal duty-cycle equalizer.
Connect DCE high (OV
DD or V DD ) to enable the internal duty-cycle equalizer.
9 CLKN
Negative Clock Input. In differential clock input mode (CLKTYP = OV
DD
or V
DD
), connect the clock
signal between CLKP and CLKN. In single-ended clock mode (CLKTYP = GND), apply the clock signal
to CLKP and connect CLKN to GND.
10 CLKP
Positive Clock Input. In differential clock input mode (CLKTYP = OV DD or V DD ), connect the differential
clock signal between CLKP and CLKN. In single-ended clock mode (CLKTYP = GND), apply the single-
ended clock signal to CLKP and connect CLKN to GND.
Typical Operating Characteristics (continued)
(V DD = 3.3V, OV DD = 2.0V, GND = 0, REFIN = REFOUT (internal reference), C REFOUT = 0.1µF, C L ≈ 5pF at digital outputs, V IN = -0.5dBFS
differential input, DCE = high, CLKTYP = high, PD = low, G/T = low, f CLK = 65MHz (50% duty cycle), C REFP = C REFN = 0.1µF to GND, 1µF
in parallel with 10µF between REFP and REFN, C COM = 0.1µF in parallel with 2.2µF to GND, T A = +25°C, unless otherwise noted.)