Rainbow Electronics MAX1444 - Manual (Page 9)

MAX1444
10-Bit, 40Msps, +3.0V, Low-Power
ADC with Internal Reference
_______________________________________________________________________________________ 9
Pin Description
PIN NAME FUNCTION
1 REFN
Lower Reference. Conversion range is ±(V
REFP - V REFN ).
Bypass to GND with a > 0.1 µF capacitor.
2 COM Common-Mode Voltage Output. Bypass to GND with a >0.1 µF capacitor.
3, 9, 10 V DD
Analog Supply Voltage. Bypass to GND with a capacitor combination of 2.2 µF in parallel
with 0.1 µF.
4, 5, 8, 11, 14, 30 GND Analog Ground
6 IN+ Positive Analog Input. For single-ended operation, connect signal source to IN+.
7 IN- Negative Analog Input. For single-ended operation, connect IN- to COM.
12 CLK Conversion Clock Input
13 PD Power Down Input. High: Power-down mode. Low: Normal operation.
15 OE Output Enable Input. High: Digital outputs disabled. Low: Digital outputs enabled.
16–20 D9–D5 Three-State Digital Outputs D9–D5. D9 is the MSB.
21 OV DD
Output Driver Supply Voltage. Bypass to GND with a capacitor combination of 2.2 µF in
parallel with 0.1 µF.
22 T.P. Test Point. Do not connect.
23 OGND Output Driver Ground
24–28 D4–D0 Three-State Digital Outputs D4–D0. D0 is the LSB.
29 REFOUT
Internal Reference Voltage Output. May be connected to REFIN through a resistor or a
resistor-divider.
31 REFIN Reference Input. V REFIN = 2 × (V
REFP - V REFN ). Bypass to GND with a >0.1 µF capacitor.
32 REFP
Upper Reference. Conversion range is ±(V
REFP - V REFN ). Bypass to GND with a >0.1 µF
capacitor.