Rainbow Electronics MAX106 User Manual

Page 13

Advertising
background image

MAX106

±5V, 600Msps, 8-Bit ADC with On-Chip

2.2GHz Bandwidth Track/Hold Amplifier

______________________________________________________________________________________

13

Principle of Operation

The MAX106’s flash or parallel architecture provides
the fastest multibit conversion of all common integrated
ADC designs. The key to this high-speed flash archi-
tecture is the use of an innovative, high-performance
comparator design. The flash converter and down-
stream logic translate the comparator outputs into a
parallel 8-bit output code and pass this binary code on
to the optional 8:16 demultiplexer, where primary and
auxiliary ports output PECL-compatible data at up to
300Msps per port (depending on how the demultiplex-
er section is set on the MAX106). The ideal transfer
function appears in Figure 2.

On-Chip Track/Hold Amplifier

As with all ADCs, if the input waveform is changing
rapidly during conversion, ENOB and signal-to-noise
ratio (SNR) specifications will degrade. The MAX106’s
on-chip, wide-bandwidth (2.2GHz) T/H amplifier reduces
this effect and increases the ENOB performance signifi-
cantly, allowing precise capture of fast analog data at
high conversion rates.

The T/H amplifier buffers the input signal and allows a
full-scale signal input range of ±250mV. The T/H ampli-
fier’s differential 50

Ω input termination simplifies inter-

facing to the MAX106 with controlled impedance lines.
Figure 3 shows a simplified diagram of the T/H amplifier
stage internal to the MAX106.

Aperture width, delay, and jitter (or uncertainty) are
parameters that affect the dynamic performance of
high-speed converters. Aperture jitter, in particular,
directly influences SNR and limits the maximum slew
rate (dV/dt) that can be digitized without a significant
contribution of errors. The MAX106’s innovative T/H
amplifier design typically limits aperture jitter to less
than 0.5ps.

Aperture Width

Aperture width (t

AW

) is the time the T/H circuit requires

(Figure 4) to disconnect the hold capacitor from the
input circuit (for instance to turn off the sampling bridge
and put the T/H unit in hold mode).

Aperture Jitter

Aperture jitter (t

AJ

) is the sample-to-sample variation

(Figure 4) in the time between the samples.

Aperture Delay

Aperture delay (t

AD

) is the time defined between the

rising edge of the sampling clock and the instant when
an actual sample is taken (Figure 4).

(-FS + 1LSB)

0

(+FS - 1LSB)

+FS

OVERRANGE + 255

255
254

129
128
127
126

3
2
1
0

ANALOG INPUT

DIGITAL OUTPUT

TO
COMPARATORS

TO
COMPARATORS

BUFFER

AMPLIFIER

INPUT

AMPLIFIER

CLOCK

SPLITTER

ALL INPUTS ARE ESD PROTECTED
(NOT SHOWN IN THIS
SIMPLIFIED DRAWING).

SAMPLING

BRIDGE

GNDI

50

Ω

50

Ω

VIN+

VIN-

GNDI

C

HOLD

50

Ω

50

Ω

CLK+

CLK-

CLKCOM

Figure 3. Internal Structure of the 2.2GHz T/H Amplifier

HOLD

CLK

ANALOG

INPUT

SAMPLED

DATA (T/H)

T/H

t

AW

t

AD

t

AJ

TRACK

TRACK

APERTURE DELAY (t

AD

)

APERTURE WIDTH (t

AW

)

APERTURE JITTER (t

AJ

)

CLK

Figure 4. T/H Aperture Timing

Figure 2. Transfer Function

Advertising