B&B Electronics EIR618-2SFP-T - Manual - Manual (Page 25)

Manual Documentation Number: EIR618-2SFP-T_4812m 25
B&B Electronics Mfg Co Inc – 707 Dayton Rd - PO Box 1040 - Ottawa IL 61350 - Ph 815-433-5100 - Fax 815-433-5104 – www.bb-elec.com
B&B Electronics – Westlink Commercial Park – Oranmore, Galway, Ireland – Ph +353 91-792444 – Fax +353 91-792445 – www.bb-europe.com
Mounting Installation
DIN-Rail Mounting
The DIN-Rail is screwed on the industrial switch when out of factory. If the
DIN-Rail is not screwed on the industrial switch, please see the following
figure to screw the DIN-Rail on the switch. Follow the below steps to hang
the industrial switch.
 Use the screws to screw on the DIN-Rail on the
industrial switch
 To remove the DIN-Rail, reverse the step 1.
Rear Panel of
the switch
DIN-Rail