B&B Electronics GW-7433D - Quick Start Guide - Manual (Page 2)

2. Hardware Installation
Step1: Connect the (R) Vs+ and (B) GND pins of the GW-7433D module to
the DC power supply (10~30VDC).
Step3: Connect the Ethernet ports of the GW-7433D and the PC to the hub
with standard network cable respectively.
Step4: Connect the CAN ports of theGW-7433D with CANopen slave devices
3. Configure the GW-7433D
Before starting the GW-7433D gateway, users need to configure the
parameters of it via the “Configuration Wizard” and “GW-7433D Utility” tools.
The details of this procedure are shown below. For more information about
setting steps, please refer to section 5 of the GW-7433D’s user’s manual.
Step1: Configure the network parameters via “Configuration Wizard”
To Use the Configuration Wizard, you must first install PCDiag.
( 8000CD:\Napdos\7188e\TCP\PCDiag\Setup\Setup.exe )
GW-7433D MODBUS TCP/CANopen Gateway Quick Start User Guide (Version 1.0, July/2008) 2