B&B Electronics 856-19717--57 - Manual - Manual (Page 14)

11
Main Configuration Screen
Press Enter, at the prompt, to display the main configuration screen.
The following displays are available:
Saved Values (displays changes made during current session)
• IP Address (must be assigned during initial configuration)
• Subnet Mask (must be assigned during initial configuration)
• Default Gateway (default router for IP traffic outside subnet)
• Server IP Addr (for the TFTP server)
• New Prom File (firmware file name)
Current Values (displays values currently in use)
• IP Address (IP address of SNMP agent)
• Subnet Mask (mask to define IP subnet)
• Default Gateway (default router for IP traffic outside subnet)
• Server IP Addr (for the TFTP server)
• New Prom File (firmware file name)
NOTE
Reboot the IE-MiniFiberLinX-II for changes to take effect. To reboot, type reboot at the prompt
on the main configuration screen, or power cycle the chassis. If a Delete key is not available,
use the F2 key. Any changes to the configuration may result in a momentary loss of connection.