Chapter 2, 3 selecting link terminal and cable, Selecting your hardware components – B&B Electronics ADAM-5000_TCP - Manual User Manual
Page 31: Ethernet network, Table 2-5: ethernet rj-45 port pin assignment
Chapter 2
Selecting Your Hardware Components
2-3 Selecting Link Terminal and Cable
Ethernet Network
Use the RJ-45 connector to connect the Ethernet port of the ADAM-
5000/TCP Series to the Hub. The cable for connection should be Category 3
(for10Mbps data rate) or Category 5 (for 100Mbps data rate) UTP/STP
cable, which is compliant with EIA/TIA 586 specifications. Maximum
length between the Hub and any ADAM-5000/TCP Series is up to 100
meters (approx. 300ft)
Figure 2-2: Ethernet Terminal and Cable Connection
Pin number
Signal
Function
1
RD+
Receive (+)
2
RD-
Receive (-)
3
TD+
Transmit (+)
4
(Not Used)
-
5
(Not Used)
-
6
TD-
Transmit (-)
7
(Not Used)
-
8
(Not Used)
-
Table 2-5: Ethernet RJ-45 port Pin Assignment
2-8
ADAM-5000/TCP User’s Manual