BabyTrend 7556PLUS - SIT N' STAND PLUS STROLLE - SERENGETTI - Manual (Page 4)

6. To attach the front child tray, push the tray onto the front frame tube,
lining up the tray between the protruding rivets. Push backward on the
latch until snapped into place. The protruding rivets on the outside of
the frame tube should be between the tray latch. Check that the tray is
securely latched in place. Fig. 5 and Fig. 6.
7. To remove front child tray, pull outward on the latches and pull outward
on the tray. Fig. 7. Please note that you may attach or remove one end
at a time.
WARNING:
The child’s tray is not a
restraint device: always secure your child with
the seat belt. DO NOT lift the stroller by the
child’s tray. Use care when attaching the child’s
tray on the stroller with a child in the stroller.
8. To attach the front canopy, line up the male fittings on the canopy with
the female fittings on the armrest and push both fittings downward until
snapped into place. Fig. 8. Push forward on the front edge of the canopy
to open.
Fig. 5.
Fig. 6.
Fig. 7.
Fig. 8.
Rivet
9. To attach the rear canopy line up the female fittings of the canopy with
the male fittings on the handle frame tube and push downward. Fig. 9.
10. To remove rear canopy reverse installation steps and pull up to remove.
Fig. 9A.
11. To remove front canopy depress the plastic attachment and pull upward
to remove. Fig. 9B.
Fig. 9.
4
Copyright © 2006 - 2007, Baby Trend Inc., All Rights Reserved.
Fig. 9A.
Fig. 9B.
WARNING:
Avoid serious injury from
falling or sliding out. Always use the seat belt.
TO SECURE FRONT/REAR SITTING CHILDREN
1 The shoulder straps of the 5-point harness has 2 attachment positions.
Select the loop position that places the shoulder strap level with, or below
the top of the child’s shoulder and feed the shoulder harness under the
correct loop. Fig. 10.
2. Carefully place the child in the stroller seat and bring the safety harness
around the child’s waist and over the shoulders. Place the crotch strap
and between the child’s legs. Insert the male end of each shoulder / waist
belt into the buckle on the crotch strap. Tighten the harness to be snug
around the child’s waist and over the child’s shoulders. Fig.11.
3. To release, apply pressure to both sides of each male clip until the clip
is released. This process requires a moderate amount of effort so as to
prevent an accidental release by your child. NOTE: Buckles may be hard
to release when 1st used.
TO SECURE CHILD