Assembly, Warning, Important – BabyTrend 9284 - EXPEDITION DLX - EVEREST User Manual

Page 4

Advertising

lever, push the wheel on farther and release lever.
Ensure that the wheels are firmly locked

into place.

NEVER

use the stroller if the

wheels are not locked into place, contact our

customer service department immediately at

1-800- 328-7363, between the hours of 8:00am

and 4:30pm PST, for assistance.

PARENT TRAY

To attach the parent tray, align the fittings on the

ends of the parent tray with the fittings on the

outsides of the handle. Hook the hole in the parent

tray. Pull outward on the opposite end while

pushing down on the tray until locked onto the

stoller handle. Please be careful not to pinch your

fingers when installing the parent tray. (Fig. 9) To

remove the parent tray, pull outward on one end of

the tray while lifting upward.

WARNING:

Do not place

hot liquids or more than 3 pounds

in the parent tray. Serious burns or

unstable conditions could result.

CANOPY

To open the canopy: push forward on the front

edge of the canopy while holding the rear of

canopy in place. (Fig. 10a)
To fold the canopy: pull backwards on the front

edge. (Fig. 10b)

CHILD TRAY

(if equipped)

To attach the front child tray: Insert the tray clip

into the fitting on the stroller’s fold joint. Check

the tray clip locks into place. (Fig. 11a) Push the

angled tray onto the post at the end of the right

armrest, while pressing downward on the snap

button, until locked into place. Rotate the tray

downward until latched onto the left armrest.

Please check that the snap button comes through

and securely latches the tray in place. (Fig. 11b)

ASSEMBLY

To open the front child tray: press inward on left

side tray release button and rotate upward on the

tray. Please see figure 11c. Please note that you

may remove the tray completely by depressing the

buttons on each side while pulling forward on

the tray.

INFANT CAR SEAT

(if equipped)

Please refer to the infant car seat instruction

manual for more details.

To Attach Car Seat using Car Seat Tabs:

Snap Car Seat into cup holders on Child Tray.

Turn the Car Seat Tabs over the lip of the Car Seat

so that it is secure (Fig. 12).

IMPORTANT!

When a Car

Seat is not attached to the Jogger Car

Seat Tabs should be rotated away from

the Child until they are secure.

PEDOMETER

(if equipped)

The pedometer is located in a seperate box inside

the main box. Silde the pedometer onto the

provided mounting bracket as shown in

Fig. 13. Instructions on how to use the pedometer

are included in the seperate box. Caution: When

folding the stroller, please make sure to rotate

the pedometer inside towards the parent tray to

prevent damage when folded.

MP3 SPEAKER

(if equipped)

The canopy comes with a speaker sewn into a

mp3 storage pocket on the side of the canopy. The

speaker has a wire with a male jack for use with

mp3 player so you and your child can listen to

music while you jog. Connect male end of speaker

wire into your mp3 player. (Fig. 14)

Your stroller is now ready to use.

ASSEMBLY

Fig. 9

Fig. 10a

Fig. 10b

Open

Fig. 12

Fig. 11a

Fig. 11b

Fig. 11c

Fig. 14

Fig. 13

Advertising